Need Help? 
Description
40mm Shaft Quick Release Wing Nut and Pressure Cup for Wheel Balancers
This quick release wing nut speeds up wheel balancing by allowing the nut to slide on and off the 40mm balancer shaft when the release lever is pressed. Fits many wheel balancers with a 40mm diameter shaft. Verify your balancer shaft diameter and thread pitch before ordering – some manufacturers used different thread configurations on 40mm shafts.
Product Information
- Store SKU: COI1514
- Component: Quick release wing nut with pressure cup for wheel balancer – 40mm shaft
- Shaft diameter: 40mm
- Listed Application: Wheel balancers with 40mm shaft from Accuturn, Atlas, Hunter (select years), Triumph, Rhino, Sicam, and Corghi
Compatible Makes / Verified Fitment Models
- Accuturn: 5500, 5600, 5800, 6000 (5100: check serial S/N 51-0623 through 51-1457)
- Atlas: Most models with 40mm shaft
- Hunter: 700, DSP9500 (made between 1990-1992)
- Triumph: Most models with 40mm shaft
- Rhino: Most models with 40mm shaft
- Sicam: Most models with 40mm shaft
- Corghi: SP750 (TB-K-0200000)
Fitment & Ordering Notes
Verify shaft diameter and thread pitch on your balancer before ordering. Hunter DSP9500 models produced after 1992 and newer Hunter SWT and DSP series use a different thread configuration; this nut may not fit those later units. Does not fit most Snap-on or John Bean units. Accuturn 5100 fitment requires serial number verification (S/N 51-0623 through 51-1457 only).
