Need Help? 
Description
Replacement Hydraulic Cylinder for Direct Lift Pro10 2-Post Car Lift – yg32-9100g / 992317
If your Direct Lift Pro10 cylinder is leaking from the rod seal, raising slowly, or failing to hold the vehicle at height, the hydraulic cylinder (ram assembly) likely needs replacement. Before ordering, verify your lift uses a hanging-style, direct-pull cylinder: the barrel mounts at the top of the column with the chrome shaft extending downward toward eye level when the lift is fully lowered. Also confirm your lift’s capacity is 10,000 lbs and that your model number matches those listed below. This cylinder will not fit lifts that use a chain-over-roller (chain-driven) style ram, or any model outside the listed fitment.
Product Information
- Brand / Equipment: Direct Lift
- Manufacturer / Reference Part Number: yg32-9100g / 992317
- Store SKU: FOD2317-1-1
- Component: Hydraulic Cylinder / Ram Assembly (single cylinder)
- Bore: 2 in.
- Stroke: 67-1/2 in.
- Outer Casing Length: Approx. 72 in. (overall approx. 74-3/8 in.)
- Outer Casing Diameter: 2-3/8 in.
- Threaded Rod Diameter: 3/4 in.
- Capacity: 10,000 lbs (10k)
- Cylinder Style: Direct-pull / inverted hanging
- Listed Application: Direct Lift Pro10 2-Post Car Hoist
Compatible Makes / Verified Fitment Models
This cylinder is designed for Direct Lift Pro10 2-post car hoists where the cylinder hangs from the top of the column and the chrome shaft exits the bottom of the barrel at approximately eye level when the lift is fully lowered.
- Direct Lift: Pro10 (2011 and newer, 10k capacity, hanging/direct-pull cylinder style)
Important: Your model number must match. This cylinder will NOT fit lifts that exceed 10,000 lb capacity, do not use a hanging-style cylinder, or use a chain-over-roller ram.
Replacement / Cross-Reference Numbers
- Direct Lift OEM: yg32-9100g
- Direct Lift OEM: 992317
- Store SKU: FOD2317-1-1
Fitment and Ordering Notes
- This listing is for one (1) hydraulic cylinder only.
- Cylinder style: inverted / hanging direct-pull – barrel mounts at column top, chrome rod extends downward.
- Verify the cylinder is approximately 72 in. along the casing before ordering.
- When replacing a cylinder, drain and flush the hydraulic reservoir and refill with fresh fluid to avoid contaminating the new cylinder and voiding the warranty.
- This part is an OEM alternative and is not produced by the original equipment manufacturer.
- Not sure of fitment? Call us at 1-866-902-6060 before ordering.
