Product Description

This is 1 seal kit for  hydraulic cylinders found in Rotary 2 post lifts 15- 18k capacity. This is for Pacoma branded cylinders.  It meets or exceeds factory specs. This seal kit will rebuild ONE cylinder if you need to rebuild both cylinders in your lift you will need TWO seal kits.

Found in Rotary 2 post lift model : SPO12 SPO15 SPO18 

Replaces Rotary Lift Part #: FJ7604,  FJ7604-12HP

Alternate Part: BH-7535-24 , ROY7604

-HOW TO IDENTIFY YOUR CYLINDER IS A PACOMA
If your lift has a pacoma cylinder : your cylinder will have  a small bleeder screw at the top of the cylinder . Look roughly 6″ below the bleeder screw near the top of the cylinder to see ID stampings. It should be stamped FJ7604 . It must also read “Pacoma” or “Made in Germany” . If these numbers match to your cylinder stampings, this is the proper seal kit for your lift. If you have your cylinder apart already, compare your piston seal with the one pictured to the left. Pacoma cylinders have distinctive blue double lipped seal on the piston ( can stain red if trans fluid is used in lift) . If you are still unsure if this seal kit will work for you, call our help hotline above and we will be glad to determine what seal kit you need.

HOW LONG DOES IT TAKE?

This kit usually takes less than an hour to install and can be done with a vice, pipe wrench and a few hand tools.

RETURN POLICY ON SEAL KITS

Our seal kits come in a sealed clear bag. Warning! Do not open bag until your verify you have the right seal kit once your cylinder is torn down. Simply remove your old seals from your cylinder and match them up by holding them next to new seals in bag. If they appear similar inside and outside diameter then you have the correct seals. If your not sure please call us before opening the bag. We will not except returns from open /used seals because you didn’t verify fitment first.

Call us at 1-866-902-6060 if you have any questions about this product or any other auto equipment questions.