Product Description

This is 1 seal kit for  hydraulic cylinders found in Rotary 2 post lifts. It meets or exceeds factory specs. It fits lifts with capacity between 7,000 & 9,000 pounds. This kit rebuilds TEXAS HYDRAULICS cylinders that rotary used through many years of production. This seal kit will rebuild ONE cylinder if you need to rebuild both cylinders in your lift you will need TWO seal kits.

HOW TO IDENTIFY YOUR CYLINDER IS A TEXAS HYDRAULIC

If your lift has a TEXAS HYDRAULICS cylinder in it, it will be approximately 72″ tall with a small bleeder screw at the top. Look approximately 6″ below the bleeder screw near the top of the cylinder to see ID stampings (see stamping example PICS 6, 7, & 8). If it reads “TXT” or “TH” followed by #s this is the proper seal kit for your lift. Also you may find FJ7664, FJ783, FJ7311. If you have your cylinder apart already, compare your piston seal with the one pictured to the left. In most 9K capacity and some 7k cylinders there is a distinctive yellow single lipped seal on the piston if they are original seals from rotary or may be black if they have been replaced. Older 7k capacity cylinders also could either be a blue colored seal or a black seal. All these seals are included in our kit so you have what you need! As long as you can locate you stampings and verify it is a texas hydraulic cylinder, this kit will work for you. (you may not need all the seals in the last picture but they are included just incase) If you are still unsure if this seal kit will work for you, call our help hotline  at 866-902-6060 and we will be glad to determine what seal kit you need.

This kit came in the following model lifts and may fit others as well

-SP55, SP80-4, SP80-5, SP84-8, SP84-9, SP89-10, SP84-11, SP84-16, SPO84, SPOA84, AR94, SP94, SPO94, SPOA84C, AR98, ARO98, spo82, spoa82, sp88, SP98, SPO88, SPOA88, DCOA7,SPOA98, AR9, ARO9, SP7, SPO7, SPOA7, SP9, SPO9, SPOA9, TLO7, SPO12-10

HOW LONG DOES IT TAKE?

This kit usually takes less than an hour to install and can be done with a vice, pipe wrench and a few hand tools.

WHAT THIS KIT WONT’ FIT!

If you see the WORD “PACOMA” or “MADE IN GERMANY” then your cylinder is not a TEXAS HYDRAULIC and this seal kit will NOT work with your lift but we offers those seal kits as well in our related products section below. ALSO there is a universal rotary 2 post seal kit that fits virtually all rotary 2 post that can be found below.

RETURN POLICY ON SEAL KITS

Our seal kits come in a sealed clear bag. Warning! Do not open bag until your verify you have the right seal kit once your cylinder is torn down. Simply remove your old seals from your cylinder and match them up by holding them next to new seals in bag. If they appear similar inside and outside diameter then you have the correct seals. If your not sure please call us before opening the bag. We will not except returns from open /used seals because you didn’t verify fitment first.

Call us at 1-866-902-6060 if you have any questions about this product or any other auto equipment questions.

Rotary Lift Hydraulic Cylinder Seals / Packing Kit for 2 post Rotary Car Lift

Replaces Rotary # FJ783-12TH

Alternate Part # BH-7511-11

SEE BELOW FOR FULL PRODUCT DESCRIPTION AND FITMENT DATA