Need Help? 
Description
Challenger 11014 Cylinder Seal Kit for Pacoma/Hyco 2-Post Lifts
When hydraulic cylinders on a Challenger 2-post lift begin leaking, rebuilding the seals is the most cost-effective repair. This kit is designed specifically for Pacoma or Hyco cylinders – approximately 68″ or 72″ tall with a 5/8″ hex bleeder screw at the top. To verify your cylinder, check for ID stampings located about 6 inches below the bleeder screw: if the stamping reads “Pacoma,” “Hyco,” or “Made in Germany,” this seal kit is correct. The distinctive blue double-lipped piston seal is another identifier. Cylinders stamped “Holmec,” “HO,” or “AA” are NOT compatible. This kit rebuilds ONE cylinder – order two kits to rebuild both columns.
Product Information
- Brand / Equipment: Challenger
- Manufacturer / Reference Part Number: 11014
- Store SKU: CHR1014
- Component: Hydraulic Cylinder Seal / Rebuild Kit
- Cylinder Type: Pacoma / Hyco (Made in Germany), 2″ bore
- Cylinder Height: Approximately 68″ or 72″ tall with 5/8″ hex bleeder screw
- Lift Capacity: 7,000 – 9,000 lbs
- Listed Application: Challenger 2-Post Lifts
Compatible Makes / Verified Fitment Models
- Challenger CL9
- Challenger CL10
- Challenger 36000
- Challenger 37000
- Challenger 39000
- Challenger 70000
- Challenger 71000
- Challenger 120000
Replacement / Cross-Reference Numbers
- Challenger 11014 (primary)
- 36135
- 16138
- 36115
Fitment & Ordering Notes
Verify the cylinder brand before ordering. Look for “Pacoma,” “Hyco,” or “Made in Germany” stamped approximately 6 inches below the bleeder screw. The blue double-lipped piston seal is also a key identifier. Cylinders stamped “Holmec,” “HO,” or “AA” require a different seal kit. Installation typically takes less than one hour using a vise, pipe wrench, and basic hand tools. Call 1-866-902-6060 if you need help confirming your cylinder type.
