Seal Kit for Rotary Lift FC5410 Bridge Jack / Rolling Jack FC5269 FC5277 FC5280 Hydraulic Cylinder Rebuild

Description

This is 1 seal kit for the hydraulic cylinders found in Rotary Rolling jacks  with model number FC5269, FC5279, FC5277, FC5278 & fc5280. These are for the jacks that roll in the middle of 4 post lifts . It meets or exceeds factory specs. This kit rebuilds Rotary cylinders that were used through many years of production. This seal kit will rebuild ONE Cylinder on 3500 lb and 4500 lb jacks but see below for stamping number info as rotary used multiple cylinders in the same model jack.

-Rotary MODELS THIS FITS 
This kit came in the following model Rotary M# FC5269, FC5279, FC5277, FC5278, fc5280 These cylinders should have a stamping number that reads “fc5185-20” stamped on the outside of the barrel. 

-HOW LONG DOES IT TAKE??  
This kit usually takes less than an hour to install and can be done with a vice, pipe wrench or spanner wrench and a few hand tools. The hard part is removing the cylinder out of the jack to rebuild!

NEED HELP CONFIRMING FITMENT?

Have your model number of your jack, any numbers stamped on your cylinder and give us a call at 866-902-6060 before ordering

-RETURN POLICY ON SEAL KITS
Our seal kits come in a sealed clear bag. Warning! Do not open bag until your verify you have the right seal kit once your cylinder is torn down. Simply remove your old seals from your cylinder and match them up by holding them next to new seals in bag. If they appear similar inside and outside diameter then you have the correct seals. If your not sure please call us before opening the bag. We will not except returns from open /used seals because you didn’t verify fitment first.

Models with OEM Cylinder: FC5269, FC5279, FC5277, FC5278 fc5280

Replaces Rotary Lift: FC5410

Alt Part Number: ROY5410, BH-7516-03