Need Help? 
Description
BendPak Round Lift Pad Weldment / Adapter – Part 5215756 for XPR and MX10 Series 2-Post Lifts
This is the OEM BendPak round-shaped steel pad weldment assembly, complete with rubber pad. It is a drop-in style foot: a steel weldment with a round peg (pin) on the bottom that seats directly into the nesting hole at the end of a BendPak 2-post lift arm – no screws required. The pin diameter is 1-3/8″ (35mm). The round shape provides multi-directional support at unibody lift points and the included rubber pad protects the vehicle underbody from scratches.
Part number 5215756 supersedes both the older 5215753 assembly and the earlier square and rectangle adapter styles – the round weldment is now the current replacement for all three variants on supported models. Please verify the nesting hole diameter in your lift arm before ordering – some BendPak models use a 1-1/2″ (38mm) pin instead of the 1-3/8″ (35mm) pin.
Product Information
- Brand / Equipment: BendPak
- Manufacturer / Reference Part Number: 5215756 (set of 4); 5300869 (single adapter)
- Supersedes / Also Replaces: 5215753
- Store SKU: BEK0588
- Component: Round Lift Pad Weldment with Rubber Pad
- Key Specs: Round shape; 1-3/8″ (35mm) nesting pin diameter; drop-in (non-screw) installation
- Listed Application: BendPak 2-post lifts with 1-3/8″ (35mm) arm nesting holes – see fitment notes below
Replacement / Cross-Reference Numbers
- 5215756 – current OEM part number (set of 4)
- 5300869 – single adapter equivalent
- 5215753 – superseded by 5215756
- Square and rectangle pad adapter styles – superseded by 5215756 (round) per original product documentation
Fitment and Ordering Notes
- Fits BendPak 2-post lifts equipped with 1-3/8″ (35mm) nesting holes at the end of the lift arms
- Listed fitment (per original documentation): PR9, BP9, XL9, most XPR models (excluding LP variants), XPR9, XPR10, MX10 models, Danmar D2-10C, Danmar D10
- Critical: Verify your arm nesting hole diameter before ordering. Some BendPak and Danmar lifts were produced with 1-1/2″ (38mm) holes. If in doubt, measure the hole before purchasing.
- If replacement rubber pads only (not the full weldment assembly) are needed, see related products.
